Installation Guide
Perfect fitment in minutes. No tools required.
5 Minutes
Install Time
No Tools
Required
Video Guide
Available
Perfect Fit
Guaranteed
Installation Steps
Follow these simple steps for perfect installation
Remove Old Mats
Remove your existing floor mats from your Ferrari. If equipped with retention clips, simply twist or pull them out from the factory anchor points. Clean the floor area to ensure proper adhesion of the new mats.
Identify Each Mat
Your FerrCarMats set is labeled for each position: Driver, Passenger, Rear Left, and Rear Right. Check the label on each mat to ensure proper placement.
Position the Mat
Place each mat in its designated position. The mat should align perfectly with the floor contours. Ensure the mat lies flat and covers the intended area completely.
Secure with Clips
Locate the factory anchor points on your Ferrari's floor (usually near the gas pedal for the driver mat). Insert the retention clips into these anchor points and twist to lock. The mat should now be firmly secured and unable to slide.
Final Check
Verify all mats are properly positioned and secured. Test the pedals to ensure no interference. The mats should fit snugly without bunching or overlapping. Enjoy your newly protected Ferrari interior!
Important Safety Notes
- Never stack mats on top of each other - this is extremely dangerous
- Always use retention clips - unsecured mats can jam pedals
- Test pedal operation before driving - ensure full range of motion
- Replace mats immediately if clips fail or mats shift during use